|Nazwa handlowa:||Kingpo||Material:||Hardness Steel|
|Standard:||IEC60061-3||HRC:||C58 to C60|
Iec 60061 3,
Go And Not Go Gauge
Gauge for testing contact-making and protection against accidental contact during insertion of lamps in lampholders E14
Purpose: to check E14 lampholders in respect of: a) contact-making with lamps having adverse dimesions.
b) protection against accidental contact with live parts, viz, the cap shell, during insertion of a lamp.
Testing: the holder is connected in the test circuit as shown. a) with switch A in position 2 and switch B open, the gauge is screwed fully home. in the position, both lamps shall light. b) with switch A in postion 1 and switch B closed, the gauge is screwed in slowly until either of the lamps lights. With the gauge held in this position, switch B is opened and the test probe at the side of the gauge is slid downwards as far as it will go into the space between the gauge and the holder. In this position the lamps shall not light.
"go" Gauges For Screw Threads of Lampholders E14, 7006-25-7
"not go" gauges for screw threads of lampholders E14, 7006-26-4
Plug Gauge For E14 Lampholder For Testing Contact Making, 7006-30-2
Gauge For Testing Contact-Making of Lamps In Lampholders E14, 7006-31-4
Plug Gauge for Lampholders E14 with candle shaped shaft for candle lamps for testing contact making, 7006-30A-1
Osoba kontaktowa: Ms.Lynette Wong